The type of information you see here depends on the type of the captured packet.Īll of the above columns can be narrowed down with the use of display filters. Info – Additional information about a captured packet. Length – This shows you the length of a captured packet. Protocol – The type of a captured packet.Ħ. Destination – The destination address of a captured packet.ĥ. Source – This is the origin of a captured packet in the form of an address.Ĥ. You can customize and adjust the value in the “Settings” menu.ģ. Time – This shows you when the packet was captured with regards to when you started capturing. Here are some details from the packet list pane that will help you with reading captures:ġ. Additional Wireshark FeaturesĪlthough capturing and filtering packets is what makes Wireshark famous, it also offers different options that can make your filtering and troubleshooting easier, especially if you’re new at this. You just hide them from the list in Wireshark. With display filters, you don’t discard any packets. With capture filters, you discard all packets that don’t fit the filters. As you’ve seen, you apply capture filters before, and display filters after capturing packets. It’s important to note the difference between capture and display filters. If you apply it, Wireshark will only show the packets where “404: Page not found” was a response.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |